2024 Hearthxy Bike Pumps Under £1,000 for sale

£28.93

Hearthxy

CO2 Inflator Set, CO2 Bike Pump Kit (1pcs CO2 Inflator Head+4pcs 16g CO2 Cartridges+1pcs Sponge Sleeve), Presta & Schrader Valve Compatible, Bicycle Tyre Pump for Road & Mountain Bikes, Quick & Easy

UK Hearthxy Bike Pumps

£28.93

Hearthxy Bike Pumps

CO2 Inflator Set, CO2 Bike Pump Kit (1pcs CO2 Inflator Head+4pcs 16g CO2 Cartridges+1pcs Sponge Sleeve), Presta & Schrader Valve Compatible, Bicycle Tyre Pump for Road & Mountain Bikes, Quick & Easy

#JI0P5NR943I8FH0RILV5

Lightweight and PortableCO2 Inflator fit Presta & Schrader valve, and CO2 cartridges are smaller and lighter than a hand pump, easily fitting into a saddle bag or pocket. The cartridges are full of compressed air and can inflate flat tire in a matter of seconds. But please note that you will find that your tire will be flat within 24 hours because CO2 will leak out of your tire faster than air. , Value KitThe CO2 Inflator Set (CO2 Cartridges x 4/ CO2 Inflator/ insulate sleeve) is a new standard of threaded CO2 Cartridge, perfect for whether your going on tough mountain range rides, or in need of fast air pressure during hot pursuit racing! With the 16g threaded cartridges, it can fill a large MTB tire. , Compatible with All Threaded CO2 CartridgesInflator head is suitable for threaded carbon dioxide filter elements of any size. Please note that the once the CO2 is released, the cartridge and the inflator head will be cold, so you need to use an insulated sleeve (included) to keep your hands protected. Once you have completed the tire inflation, do not leave the tire on the side of the road so that others can pick it up. The carbon dioxide container is recyclable and one-time use only. , Suitable for Road/Mountain Bike Tires16g cartridges inflate road tires to 100 psi and mountain bike tires to about 40 psi. , Note before PurchaseDo Not store the cartridges in or near any hot place, such as under direct sunshine, near a heat source or left in a car. Do Not use low quality CO2 head. Make sure the device has fully punctured the head of the cartridge. If not, or you find that the gas being released slowly or the gas is freezing the head, discharge the gas for a few minutes until the bottle is fully empty, then dispose of it properly